Manipulating a GPIO on VAR-SOM-43

Moderator: Oren.R

zoombach
Posts: 2
Joined: Wed Feb 10, 2016 5:39 pm

Manipulating a GPIO on VAR-SOM-43

Postby zoombach » Mon Feb 15, 2016 5:51 pm

Using the AM43 Custom Board, The Yocto 1.8 Fido, and following these instructions:
http://variwiki.com/index.php?title=VAR-SOM-AM43_GPIO

I tried Header J20 Pin 2 (GPIO1_4) and it would not work. I was just trying to blink an LED like I can with the Beaglebone.

I also tried Header J19 Pin 2 (GPIO2_3) and it did not work. On boot up the LED came on but I could not control it.

I am booting off of an SD card.

Are these GPIOS really hooked up to use in the Yocto 1.8 Fido build? Or are they mapped some other way?

Thanks,
Lyle

Return to “Yocto”

Who is online

Users browsing this forum: No registered users and 1 guest

cron