Thank you for your reply.
I done the test using v51 (Fido) (not with jethro, as we are not using jethro for our device).
I downloaded the sd card image from ftp://ftp.variscite.com/VAR-SOM-MX6/Sof ... cy-images/
File used for SD card is mx6-som-recovery-sd.v51.img.gz
Hardware used is
SOM module : VAR-SOM-MX6 Rev 2.11 and carrier board VAR-MX6CustomBoard Rev 1.3
When resumed from standby i.e using echo standby > /sys/power/state
, ethernet also resumes normally.
But when used echo mem > /sys/power/state
command to put the system to low power. After resume the ethernet does not start. Please see attached log file.
Am I doing anything wrong here?